1 pair 2pcs X70 Headlamp Paint Protection Film / Precut [READY STOCK]

Headlight protection film with precut pattern according to Proton X70 model.

Material : TPU

Qty.: 1 set as per picture

Colour : Transparent

Warranty : Product will be free from any defects upon receiving.

Installation:

1. Clean surfaces, ideally with a Isopropyl alcohol (IPA) and microfiber cloth.

2. Spray your hand with slip solution prior remove the liner to prevent finger prints or marks on the adhesive.

3. Remove the liner from the film and spray slip solution on the adhesive side.

4. Lay the film onto the headlights or panel and slide into position.

5. Once the film is positioned, spray with slip solution so the squeegee will slide across it. Use the squeegee to apply mild pressure and slowly push out the air and moisture from below the film. For curved sections, apply some stretching force to get the contours of the bodywork and avoid creasing. If you are not satisfy with the position, remove and start again.

6. Continue working the film with the squeegee until all air bubbles are out and the edges are securely in place. (If any edges are not sticking down, apply some pressure and use a microfiber to clean the edges until no moisture at the edges)

7. Finally, park the car under the sun for couple of hours to speed up the drying time. Any edges lifting up in drying period can be pushed down with aid of squeegee and microfiber cloth in mild pressure.

Remarks :

1. Slip solution : Baby shampoo (preferably Johnson's Baby Shampoo) mixed with water. 5 drips for 1 litre water